MH-6J 3D Model DevBlog P. 11
В загальних рисах розповів про ключові моменти, які виникали при створенні панелі приладі для кокпіту гелікоптера MH-6J Little Bird.
MH-6J 3D Model DevBlog P. 10
Відео про запікання текстур в Marmoset Toolbag 4, та організація сцени в Blender.
MH-6J 3D Model DevBlog P. 9
Відео про те, як я зробив ретоп та ЮВ меппінг своєї моделі гелікоптера всього за 11 годин часу.
MH-6J 3D Model DevBlog P. 8
Завершив хай-полі екстер’єру фюзеляжу.
MH-6J 3D Model DevBlog P. 7
Фіналізував базові форми фюзеляжу. Додаю деталі…
A/MH-6J 3D Model DevBlog P. 6
Starting Work on the Fuselage: ImageModeler and Camera Match in Blender I’m gathering photos from various angles to use in ImageModeler. After many attempts, I’ve concluded that it’s better to use a minimal number of photographs. Currently, I’m using photos of a variant that isn’t exactly the one I need, so I’m working with what’s […]
A/MH-6J 3D Model DevBlog P. 5
Finishing the MH-6J Main Rotor Base Mesh I’ve reached the most complex part of the rotor. There are no photos of the individual components, and I lack a precise understanding of the assembly. However, I’ve tried my best to figure it out. Fortunately, I have a photo of one key component. That’s where I’m starting… […]
A/MH-6J 3D Model DevBlog P. 4
Continuing work on the main rotor base mesh. It was quite difficult to figure out the complex shape of the Mast Assembly. I utilized a combination of AI generation from photos, Image Modeler, and Camera Match in Blender to recreate at least an approximate version of this part. I am currently assembling the rotor elements […]
A/MH-6J 3D Model DevBlog P. 3
Continuing my work on the MH-6J Little Bird main rotor. Today, I tested a new AI model for 3D generation. The pitch housing consists of several parts that connect to the main rotor head. It was difficult to figure out the assembly from general photos alone, but eBay listings were a huge help. Some sellers […]
A/MH-6J 3D Model DevBlog P. 2
A Tale of Image Modeler and Two Blenders… I didn’t get a lot done today because much of the time went into figuring out a workflow for photo-based 3D modeling. First, I finished the basic mesh (the blocking) of the main rotor hub component I started working on in the previous post. At this stage […]
